Front Leveling Kit

C

Caviar

Member
Jun 20, 2024
34
21
USA
Has anyone done a front leveling kit on the factory suspension?

Westcott has this preload collar lift kit. It's a small front and rear lift:
westcottdesigns.net

2024 Lexus GX 550 Preload Collar Lift Kit - by Westcott Designs

2024 Lexus GX 550 Preload Collar Lift Kit from Westcott Designs! This kit gives a full 2.5 inch lift in the front and .75 inch in the back.
westcottdesigns.net westcottdesigns.net

Any other options available? Any issues with e-KDSS or ride quality?
 
I gambled and started looking at Land Cruiser 1.5” leveling spacers

I ordered a set from Tuff Country but their service is HORSE$HIT and I can’t even get an email or call back. Do NOT order from these guys

I chatted with TheYotaGarage - they have it on their website but are probably 2 months out

Who knows what will work and when it will be available 🤷‍♂️
 
Last edited:
Has anyone measured the height difference between the front and back? With the high payload and tow rating I’m sure it’s sizable. Although I have no plans on towing anything more than a golf cart/side by side I think I’m going to wait for something with some adjustability. Just in case…
 
It's about 37.25 in the rear and about 35.5 in the front, so about 1.75 difference. That equates to the Wescott Designs kit taking it up 2.5 in the front and .75 in the rear for a level GX550.
 

Attachments

  • 20240727_142549.jpg
    20240727_142549.jpg
    73.2 KB · Views: 589
  • 20240727_142607.jpg
    20240727_142607.jpg
    85.8 KB · Views: 264
SethGX said:
It's about 37.25 in the rear and about 35.5 in the front, so about 1.75 difference. That equates to the Wescott Designs kit taking it up 2.5 in the front and .75 in the rear for a level GX550.
Click to expand...
Here are the front & rear measurements after the Westcott Designs pre-load collar lift and 35x12.5x17 wheels and tires:

38-3/4" Front

39-7/8" Rear

or 1-1/8" higher rear

2--REAR 39 7-8 Westcott lift.JPG

1--FRONT 38 3-4 Westcott lift.JPG
 
SethGX said:
It's about 37.25 in the rear and about 35.5 in the front, so about 1.75 difference. That equates to the Wescott Designs kit taking it up 2.5 in the front and .75 in the rear for a level GX550.
Click to expand...
To get a accurate height measurement you should start from the center of the wheel to the lip of the fender well. I learned this when lowering my Explorer ST and was informed by someone on a different forum. This is relevant for both lowering and lifting a vehicle. Below is more information on this from Bilstein.

How do I measure ride height?

Measure from the center of the wheel to the center of the fender opening.
academy.bilsteinus.com academy.bilsteinus.com
 
True - this method takes the tires out of the equation because you are essentially measuring center of hub to fender line.
 
Method 703 wheels, 17-inch diameter, +35mm offset. Westcott Designs told me the specs and Westcott ordered and installed them with the new 35x12.5x17 Toyo Open Country AT3 tires in Load Range C.
 
Bluegill said:
Method 703 wheels, 17-inch diameter, +35mm offset. Westcott Designs told me the specs and Westcott ordered and installed them with the new 35x12.5x17 Toyo Open Country AT3 tires in Load Range C.
Click to expand...
What was the total cost to Westcott do all that?
 
You must log in or register to reply here.

Similar threads

S
Peak Suspension Spacer Lift - Opinions
Replies
9
Views
473
German88
G
rangertrace
Westcott Leveling Kit and 35s
2
Replies
30
Views
2K
S SUBERI
S SUBERI
Caraddictionisreal
Fender Liner Rub...Suggestions Needed
Replies
6
Views
289
Caraddictionisreal
Caraddictionisreal
L
Grew up around Chevy and Mopar cars
Replies
2
Views
339
Cajun Heat
C
Bluegill
🛠️ Member Build Overtrail Updgrades
5 6 7
Replies
127
Views
21K
Bluegill
Bluegill

Latest Discussions

GX550 Poll

Waiting times for Lexus GX 550, how long did you have to wait?

  • 2 weeks

    Votes: 3 10.0%

  • 1 - 2 months

    Votes: 6 20.0%

  • 3 - 5 months

    Votes: 2 6.7%

  • More than 5 months

    Votes: 19 63.3%
See comments…
Back
Top